FLIR Ariel CM-3202-11-I - Figure 7: System Cable; Figure 8: Internal Interfaces; Internal Interfaces; System Cable

Introduction
CM-3202-11-I Installation and User Guide Revision 100
June 2020
10
This document does not contain any export-controlled information.
2.5.1 System Cable
The camera’s built-in system cable includes an RJ-45 Ethernet jack, and five (2) two-wire leads that
provide audio input and output, alarm input and output, and 12VDC power connections. The cable
includes an LED that flashes green to indicate power on and network activity.
Figure 7: System Cable
Connector
Black RJ-45
Pink AUDIO OUT
Light green AUDIO GND
Light blue MIC IN-
Yellow black MIC IN+
Purple ALARM COM
Blue ALARM OUT
Gray ALARM IN
White ALARM GND
Black 12 VDC-
Red 12 VDC+
2.5.2 Internal Interfaces
With camera’s top cover removed, you can access the camera’s default and reset buttons, along with
the camera’s microSD card slot. For instructions how to remove the top cover, see
Mounting
Instructions.
Figure 8: Internal Interfaces