Configuration
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
Find file: Browse for and upload a signed 16-bit PCM .WAV file with a sample rate of 8kHz.
Delete: Deletes an existing audio file.
Delete All: Deletes all uploaded audio files.
5.11 Snapshot Page
On the Snapshot page, you can configure the settings for photo snapshot alarm actions.
Figure 68: Snapshot Page
Pre-Event Capture Count: Specify the number of frames to capture prior to the event snapshot, between
1-10. The default is 3 frames.
Event Capture Interval: Specify the amount of time between snapshots, between 1-10 seconds. The
default is 1 second.
Post-Event Capture Count: Specify the number of frames to capture after the event snapshot, at least 1.
The default is 3 frames.
To apply changes to these settings, click Save.
5.12 Recording Page
On the Recording page, you can configure the settings for recording alarm actions.
Figure 69: Recording Page - One Shot Record Status
To record video, at least one stream must be set to H.264. See Video Page.
Record Type: Select Video or Audio and Video.
To Next Page
Loading...
