FLIR Ariel CM-3202-11-I - I;O Page; Figure 34: I;O Page - Alarm Input Pin Settings

Operation
CM-3202-11-I Installation and User Guide Revision 100
June 2020
34
This document does not contain any export-controlled information.
• Color: Locks camera in daytime mode.
• B/W: Locks camera in nighttime mode.
Image Rotation:
• Flip: Flips the image upside-down.
• Mirror: Displays the image from a different angle.
• Both: Displays the image upside-down from a different angle.
• OFF (default).
Video Format: Select the desired video format, PAL or NTSC (default). Then, click Save. The camera
reboots.
If you made any changes on the Visible page, click Save to apply the changes. Click Reset to discard
changes and revert to the last saved settings.
4.5 I/O Page
The I/O page enables you to configure the camera’s alarm input and output pin states.
Figure 34: I/O Page - Alarm Input Pin Settings
To configure the alarm input pin state
1. Click Input.
2. Click Alarm.
3. Select whether the display state of the alarm input pin is On or Off.
4. Select the state in which the alarm input pin is not alarmed: Open (default) or Closed.