Configuration
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
o IPv4 Subnet Mask: Determines whether destinations are on the same subnet. FLIR
recommends using the default address: 255.255.255.0. If the subnet mask is not properly
configured, the camera might not be able to communicate with other devices on the network.
o IPv4 Default Gateway: Used to forward frames to destinations in other subnets. An invalid
gateway setting causes transmission to destinations in other subnets to fail.
o Primary DNS: Specify the primary domain name server (DNS) address.
o Secondary DNS: Specify the secondary DNS address.
• PPPOE: The camera connects to the network via a DSL modem using Point-to-Point Protocol over
Ethernet (PPPOE). Manually specify the User Name and Password for the PPPOE account.
IPv6 Enable: If you are using IPv6, move the slider to the right to enable IPv6, and then configure:
• Accept IPv6 Router Advertisement – Move the slider to the right to accept IPv6 router advertisement.
By default, Accept IPv6 Router Advertisement is disabled.
• Enable DHCPv6: If the camera is connected to a network with a DHCP server that supports IPv6
addressing, move the slider to the right. By default, DHCPv6 is disabled.
If IPv6 is enabled, but DHCPv6 is disabled, manually specify the camera’s:
• IPv6 Address: Identifies the camera on the network. Subnet Prefix Length: Specify the subnet prefix
length (1-128 digits).
• IPv6 Default Router Address: Specify the IPv6 default router address. Subnet Prefix Length: Specify
the subnet prefix length (1-128 digits).
• IPv6 DNS: Specify the IPv6 DNS address.
Figure 44: QoS Settings
Enable QoS (Quality of Service): Determines resource control and traffic prioritization according to
priority assigned to applications or users, assuring a certain level of data flow performance. If you are
using QoS, move the slider to the right to enable it. You can then separately configure the following for
QoS Priority 1 and 2:
• IPv4 Address: Specify an IPv4 address for each QoS priority level.
• Netmask Bit: Specify a value between 0-32 for each QoS priority level.
To Next Page
Loading...
