FLIR Ariel CM-3202-11-I - Figure 81: Firmware & Info Page

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
67
This document does not contain any export-controlled information.
• See the camera’s current firmware version, serial number, MAC address, model, and up time
• Upgrade the camera's firmware
• Reset the camera to its factory defaults
• Reboot the camera
• Import camera settings
• Export the camera’s current settings
• Download system information FLIR Support can use for troubleshooting
Figure 81: Firmware & Info Page
Device Name: Specify a unique, friendly name for the camera, using only alphanumeric characters. The
default name for the camera is the camera model followed by the camera’s serial number.
To upgrade the camera's firmware
1. Under Firmware Upload, click Find file.
2. On your computer or network, browse to and select the firmware file.
The file name appears (for example, Ariel2FHD_20200610.bin).
Note
The folder includes a checksum file, which can be used to check file validity using the
checksum validation software of your choice.