FLIR Ariel CM-3202-11-I - Page 76

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
68
This document does not contain any export-controlled information.
Caution
Only upgrade to firmware developed for the Ariel Full HD Mini-Dome CM-3202-11-I camera.
3. Click Upgrade.
The camera uploads and installs the firmware, which takes about three minutes. After installing firmware,
the camera reboots.
Reset factory default and reboot
Click Full Reset to return the camera its original factory configuration, including the camera’s original
networking settings.
Caution
Clicking Full Reset causes the camera to lose all network settings.
Attention
En cliquant sur Réinitialisation complète, la caméra perd tous les paramètres réseau.
Click Partial Reset to return the camera to its factory configuration, except for the camera’s network
settings (IP address, subnet mask, and default gateway), video format, and image rotation settings.
Click Reboot to restart the camera without affecting the configured settings.
To import settings using a previously exported settings file
1. Under Import Setting, click Find file.
2. On your computer or network, browse to and select the settings file.
3. Click Import to upload the file.
To export the camera’s current settings
1. Under Export Setting, click Export.
In Internet Explorer, an information bar appears.
2. In Internet Explorer, click Save. For other browsers, save the file.
Support package: To download camera log files for FLIR Support personnel, click Download.