Installing and Connecting the Camera
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
Caution
• When powered by PoE, this product must be connected only to a PoE network.
• The PoE supply’s rated output is 48VDC, 0.2A.
• If the camera is installed for outdoor use, the PoE supply must be installed with proper
weatherproofing.
• As a Listed Power Unit, the PoE should be marked as “LPS” or “Limited Power Source”.
• This product shall be installed by a qualified service person. Installation shall conform to all
local codes.
Attention
• Lorsqu'il est alimenté par PoE, ce produit doit être connecté uniquement à un réseau PoE.
• La puissance nominale de l'alimentation PoE est 48VDC, 0.2A.
• Si la caméra est installée pour une utilisation extérieure, l'alimentation PoE doit être installé
avec l'étanchéisation appropriée.
• Comme une unité d'alimentation «Listed», le PoE doit être marqué comme «LPS» ou «Limited
Power Source".
• Ce produit doit être installé par un technicien qualifié. L'installation doit se conformer à tous
les codes locaux.
3.5 Connecting and Discovering the Camera
To view and configure the camera via a LAN, you must attach the camera via the network switch or
router to the same subnet (network segment or VLAN) as the computer that manages the unit.
FLIR recommends using the Discovery Network Assistant (DNA) software tool to discover the camera on
the network.
To discover the camera on the network using the DNA tool
Download DNA from FLIR.com (see 2.3 Accessing Product Information from the FLIR Website).
Run the dna.exe file by clicking the icon.
DNA opens and the camera appears in the Discover List.
Figure 16: DNA Discover List
To Next Page
Loading...
