Configuration
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
Figure 54: FTP Page
Server Address: Specify the FTP server’s IP address.
Port: Specify the FTP server’s port number as 21 (default) or between 1025-65535.
User Name: Specify the user name of the account the camera uses to access the FTP server.
Password: Specify the password of the account the camera uses to access the FTP server.
Mode:
• Active: The camera maintains a connection with the FTP server. This mode uses more network
bandwidth but provides instant FTP responses.
• Passive (default): The camera only establishes a connection with the FTP server when necessary,
which uses less network bandwidth. In addition, in passive mode, the client initiates both
connections to the server, solving the problem of firewalls filtering the incoming data port connection
to the client from the server. In order to support passive mode on the server-side firewall, the
following communication channels must be opened:
o FTP server's port 21 from anywhere (client initiates connection)
o FTP server's port 21 to ports > 1023 (server responds to client's control port)
o FTP server's ports > 1023 from anywhere (client initiates data connection to a random port
specified by server)
o FTP server's ports > 1023 to remote ports > 1023 (server sends ACKs and data to client's
data port)
To apply any changes to the settings, click Save.
5.6 SD Card Page
The camera can locally store video clips and snapshots on a microSDXC card, which is not supplied with
the camera (minimum 4GB; maximum 256GB; formatted as a single partition). Before using a
microSDXC card, it must be formatted. On the SD Card page, you can format and configure the
microSDXC card.
To Next Page
Loading...
