Configuration
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
The Enable SSL setting on the TLS/HTTPS screen affects whether the TLS port (443) and the Web port
(80) are enabled or disabled:
Enable SSL
Setting
TLS HTTP
On On On or Off
Off (default) Off On
HTTPS Only On Off
Also, to ensure communication with the camera, the ONVIF and RTSP ports cannot be disabled.
5.14.6 IP Filter
You can restrict access to the camera by either allowing or denying up to 10 specific IP addresses.
Figure 80: IP Filter Settings
To allow access for one or more specific IP addresses
1. For Mode, select Allow.
2. Move the Enable slider to the right for each IP address for which you are allowing access.
3. Specify the IP Address.
4. Click Save.
To deny access for one or more specific IP addresses
1. For Mode, select Deny.
2. Move the Enable slider to the right for each IP address for which you are denying access.
3. Specify the IP Address.
4. Click Save.
The default IP filter Mode is OFF.
5.15 Firmware & Info Page
On the Firmware & Info page, you can:
• Specify a unique name for the camera
To Next Page
Loading...
