FLIR Ariel CM-3202-11-I - Figure 49: Date & Time Page - NTP Selected; Figure 50: Date & Time Page - Manual Selected

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
45
This document does not contain any export-controlled information.
Figure 49: Date & Time Page - NTP Selected
Select the date and time mode:
• NTP (Network Time Protocol; default): The camera’s date and time are synchronized with an NTP
server.
• Manual: Manually specify the camera’s date time.
Figure 50: Date & Time Page - Manual Selected
You can copy the PC’s current time or manually specify the camera’s time and date.
Time Zone: Regardless of whether NTP or Manual is selected, specify the time zone in which the
camera is located. If you leave the drop-down list on the left blank, you can define the time zone
according to GMT offset. Otherwise, you can select a continent and city/time zone.
When NTP is selected, you can specify:
• NTP Server:
o From DHCP: The DHCP server provides the NTP server’s IP address, which appears in the
DHCP Server Assigned field.