The Alarm History tab provides details of alarms
and the date and time that they were triggered and
cleared / acknowledged. The Alarm history can
display up to 1,000 alarm events and displays them
sorted by time.
When the Alarm history has reached its capacity
of 1,000 entries, the oldest events in the list will be
automatically deleted when subsequent new alarm
events occur.
Alarm events will only be removed from the list if:
• Clear alarm history is selected.
• a Systems and Data Reset is performed.
• it is automatically deleted due to the list reaching
its capacity of 1,000 events.
Active Alarms
The Active Alarm tab lists all currently active alarms.
Alarms are removed from the list when:
• the conditions that triggered the alarm are no
longer present.
• the alarm has been disabled.
Accessing the Alarm Manager
From the Homescreen:
1. Select Set-up.
2. Select Alarms.
The Alarm Manager is displayed.
Enabling and disabling an alarm
You can enable and disable alarms using the Alarm
Manager.
From the Alarm Manager Homescreen > Set-up >
Alarms:
1. Select the Settings tab.
2. Select the alarm category for the alarm you want
to enable / disable.
Alarms are displayed in the Alarm Manager in
the following categories:
• Safety Alarms
• General Alarms
• * Switch Panel Alarms
• Engine Alarms
Note: * The Switch Panel Alarms category is only
displayed when you have a correctly congured
Raymarine Digital Switching system installed on
your vessel.
3. Select on the relevant alarm.
Alarms with Black text are currently enabled and
alarms with Gray text are currently disabled.
The alarm will be expanded to show the alarm
settings.
If the Enable box is ticked then the alarm is
currently enabled.
4. To disable the alarm, select the Enable tick box
so that the tick is removed.
5. To enable the alarm, select the Enable tick box
so that a tick is displayed.
Changing alarm thresholds
Alarm thresholds are the attributes associated with
each alarm which dictates when the alarm event is
triggered.
With the Alarm Manager displayed:
1. Select the Settings tab.
2. Select the alarm category for the alarm you want
to change the thresholds of.
3. Select on the relevant alarm.
The alarm will be expanded to show the alarm
settings.
4. Select the relevant threshold.
The numeric adjustment control is displayed.
Alarm management
107
To Next Page
Loading...