Chart text
If supported by your cartography type, chart text
such as place names and caution text etc. can be
switched on and off.
1. Chart text On.
2. Chart text Off.
The default setting for Chart text is On.
Switching chart text on and off
The Chart text can be switched on and off by
following the steps below.
From the Chart application menu:
1. Select Presentation.
2. Select Overlays.
3. Select Chart Text: so that On is selected to turn
chart text on, or
4. Select Chart Text: so that Off is selected to turn
chart text off.
Chart boundaries
Chart boundary lines can be shown on-screen,
these lines indicate the boundary of the cartography
currently in use.
1. Chart boundaries On.
2. Chart boundaries Off.
By default Chart boundary lines are switched On.
Switching chart boundary lines on and off
Chart boundary lines can be switched on and off by
following the steps below.
From the Chart application menu:
1. Select Presentation.
2. Select Overlays.
3. Select Chart Boundaries: so that On is selected
to display boundary lines, or
4. Select Chart Boundaries: so that Off is selected
to turn the boundary lines off.
Range rings
Range rings provide an on-screen incremental
representation of distance from your vessel to help
you judge distances at a glance.
The rings are always centred on your vessel, and the
scale varies to suit your current chart range. Each
ring is labelled with the distance from your vessel.
By default range rings are switched off. Range rings
are not displayed in 3D view.
Switching range rings on and off
The range rings can be switched on and off by
following the steps below.
With the Chart application in 2D view:
1. Select Menu.
2. Select Presentation.
3. Select Overlays.
4. Select Range Rings: so that On is selected to
display Range Rings, or
5. Select Range Rings: so that Off is selected to
turn the Range Rings off.
190
To Next Page
Loading...