FLIR RAYMARINE A75 WiFi - Keypad Controls

Descrip-
tion Functions
1 Touch-
screen
Touch the screen to operate functions,
including all menu operations.
2 Power • Press once to switch the unit on.
• When powered on, press the Power
button again open the Shortcuts page.
• When powered on, press and hold to
put the display into Standby mode.
• If an integrated pilot is engaged, press
and hold to put the autopilot into
STANDBY mode.
3
Card
reader
Open the card door to insert or remove
a MicroSD card. There are 2 card slots
(labelled 1 and 2), used for electronic
charts and archiving waypoint, route, track
and settings data.
Keypad controls
Connecting the keypad allows you to control your
multifunction display remotely.
1. Home — press to return to the Homescreen.
2. Menu — accesses menus. Press again to close
menus.
3. UniController — provides a rotary control and
a joystick that includes an OK push button for
using menus and applications.
4. Back — press to return to a previous menu or
dialog level.
5. - (Minus/Negative symbol) — press to range out.
6. + (Plus/Positive symbol) — press to range in.
7. Active — press to switch the active pane, or
to switch the active multifunction display (in
multiple display systems).
8. Waypoint / MOB — press and release to
access the waypoint options. Press again to
place a waypoint. Press and hold to place a
Man Overboard (MOB) marker at your current
position.
9. Standby (Auto) — press to disengage
integrated autopilot, press and hold to activate
Auto mode on integrated autopilot.
10. Power — see table below:
Congura-
tion
Display
State
Momentary
press
Press and
hold
Off / Standby * Power on
—
1
Multifunction
display
On Open
Shortcuts
page
Power off
/ put into
Standby
All displays
Off or in
Standby
* Power on
all displays
—
All displays
On
Open
Shortcuts
page on
active display
Power down
all displays
Multiple
multifunction
displays
1 Display
On and 1
display Off
or in Standby
Open
Shortcuts
page on
active display
Power down
active display
Note: * Only applicable to eS and gS Series
displays. a Series, c Series and e Series
displays cannot be powered on using the
keypad.
Note: In a multiple display conguration,
where displays are in different states, displays
that are turned off can only be turned on using
the Power button on the display.
11. Direction of Joystick Up.
34