FLIR RAYMARINE A75 WiFi - Customizing the Data Application

Set boat details such as
number of engines, fuel
tanks, and batteries
•
17.5 Setting boat details
from the Data application
Set the maximum RPM and
Red zone range
• 17.6 Setting engine RPM
range and red zone
Change the units of
measurement
• Changing units of
measure from the Data
application
Adjust wind data response
times
•
Setting wind damping
from the Data application
Reset minimum and
maximum data readings
• Resetting minimum and
maximum readings
Reset all datapages to
defaults
• Resetting all datapages
Note: Relevant data must be available to your
multifunction display.
17.2 Customizing the Data
application
Changing the order of datapages
From the Customize menu: Menu > Customize.
1. Select Edit Page.
2. Select Move Page Up or Move Page Down.
Each time Move Page Up or Move Page Down
is selected the datapage will be moved 1 space
in that direction.
Customizing datapage content
using touch
On touchscreen multifunction displays you can
customize a data item by pressing and holding on
the item onscreen.
From the Data application:
1. Display the datapage that contains the data item
you want to change.
2. Touch and hold your nger on the data item.
After approximately 3 seconds the data item is
highlighted and the Select Data Category menu
is displayed.
3. Navigate the menu to locate the data item you
want to use.
4. Select the data item.
The selected data item is now displayed in place
of the original data item.
Customizing datapage content
The content of datapages can be customized using
the menu.
From the Customize menu: Menu > Customize.
1. Select Edit Page.
2. Select the cell you want to change.
3. Select Select Data Category.
4. Browse to the required data category.
5. Select the data item you want to display.
6. Repeat steps 2 to 5 for all the data items you
want to change.
Adding a new datapage
You can add your own customized datapages to the
data application. The total number of datapages
including pre-congured pages is 10.
From the Customize menu: Menu > Customize.
1. Select Create New Page.
A list of available page layouts is displayed.
2. Select the required page layout.
The new page is displayed.
Data application
277