17.4 Engine identication
Engine data can be displayed on your MFD using
the Data application, which provides some preset
Engine pages for displaying some of the most
common types of engine data.
Important: Before you can display Engine data
on your MFD, you must:
• Ensure that your MFD is running LightHouse
software version 8 or later.
• Refer to the important “Engine setup with
an ECI interface” and “Using the engine
identication wizard” information.
• Make the data connections, according to
the instructions provided in the 87202 ECI
Installation instructions.
• Ensure all data buses are powered up (including
engine data CAN buses, gateways, and also the
SeaTalk
ng
bus).
• Start the engine. It is important that only one
engine is running at a time, to ensure that the
system can isolate the correct engine data
message.
• Run the Engine identication wizard to ensure
that your engines are displayed in the correct
order in the Data application.
282
To Next Page
Loading...