• A FAT 32 formatted MicroSD card with SD card
adaptor.
Note: Do not use a cartography chart card for
software updates or user data / settings backups.
1. Go to the Software update section of the Rayma-
rine
®
website
www.raymarine.com/software
2. Compare the latest available software against the
software version of your Raymarine
®
products.
3. If the software on the website is newer than the
software on your products download the relevant
software package.
4. Insert the MicroSD card into your PC or Mac card
reader.
Depending on your computers card reader type
an SD card adaptor may be required.
5. Unzip the downloaded software package ‘zip’ le
to the MicroSD card.
6. If used, remove the MicroSD card from the SD
card adaptor.
Performing software updates
Attention Do NOT perform software updates whilst
your boat is underway.
1. Backup your user data and settings.
2. Insert the MicroSD card containing software
update les into the card reader of your Data
Master MFD.
If the inserted card contains updated software
for a device on your system, after a few seconds
a pop-up message is displayed. If you need
to re-install or downgrade software then select
the Check Card for Updates option from the
Maintenance menu: Homescreen > Set-up >
Maintenance.
3. Select Yes.
A second pop-up is displayed.
4. Select OK.
The Software updates page is displayed.
1
No software update available on memory card
2
Software update available on memory card
3
Software on memory card is older than the
software installed on the product
4
Software update available on memory card
5
Partial software update available on memory card
6
Software version on memory card is the same as
the software installed on the product
If a software update is available on the memory
card the Update? box is automatically ticked.
5. On touchscreen displays you can select and hold
on the available software version to see further
details about the software that will be installed.
6. Select the products that you want to update.
1
Software downgrade will be performed
2
The same software version will be re-installed
7. Select Install Now.
The installation process will begin.
During the update process, details of each
product’s progress is displayed. The MFD serving
the software updates will be the last device to be
updated.
8. Select OK on the Software Updates pop-up
message.
9. Remove the MicroSD card from the card reader.
Note: If you switch on a display when it has a
memory card already inserted which contains
software update les saved to the root directory, a
standalone software update will be started for that
display only.
58
To Next Page
Loading...