preferences page. The system preferences page
can be accessed from the homescreen: Set-up >
System Settings > System Preferences > System
Datum.
When you change the datum for your multifunction
display, the chart grid will subsequently
move according to the new datum, and the
latitude/longitude of the cartographic features will
also change accordingly. Your multifunction display
will attempt to set up any GPS receiver to the new
datum, as follows:
• If your multifunction display has a built in GPS
receiver it will automatically correlate each time
you change the datum.
• If you have a Raymarine GPS receiver using
SeaTalk or SeaTalk
ng
, it will automatically
correlate each time you change the datum on the
multifunction display.
• If you have a Raymarine GPS receiver using
NMEA0183, or a third-party GPS receiver, you
must correlate it separately.
It may be possible to use your multifunction display
to correlate an NMEA0183 GPS receiver. From the
homescreen go to Set-up > System settings > GPS
Set-up > View Satellite Status. If the datum version
is displayed, it may be possible to change it. From
the homescreen go to Set-up > System settings >
Data Sources > GPS Datum.
Note: Raymarine recommends that you check the
displayed vessel position in the chart application
against your actual proximity to a known charted
object. A typical GPS has an accuracy of between
5 and 15 m.
Using Chart Call-outs
On touchscreen MFDs, touching an area onscreen
displays a “Call-out” which provides information
about the selected location or object.
Call-outs are enabled by default and can be disabled
from the Homescreen: Homescreen > Customize >
Display Preferences > Chart Touch Call-outs.
1. Touching an area or object opens the Call-out.
The Call-out will close automatically after 10
seconds. Alternatively, it can be closed by
touching a different location, by panning or
zooming the chart area, or by pressing the Back
button.
2. Touch the Call-out to open the Context menu.
3. If you did not select the correct location, you can
reposition the Call-out by swiping your nger over
another area or object.
Chart context menu
The context menu provides positional data for the
cursor position in relation to your vessel and access
to menu options.
The following menu options are available:
• Goto Cursor
• Stop Goto / Stop Follow
• Place Waypoint
• Photo
• Tide Station (only available if a tide station is
selected.)
• Current Station (only available if a current station
is selected.)
• Pilot Book (only available at certain ports.)
• Animate (only available if a tide or current station
is selected.)
• Chart Objects
• Find Nearest
• Measure
• Build Route
• Acquire Target (only available if Radar overlay is
switched on.)
• Slew thermal camera (only available when
thermal camera is connected and operating.)
Accessing the context menu
1. Non-touchscreen and HybridTouch displays:
i. Move the cursor over the area or object and
pressing the OK button.
2. HybridTouch and Touch only displays:
i. Select and hold on an area or object, or
ii. With the Chart Call-out displayed select the
Call-out box.
Chart application
165
To Next Page
Loading...