FLIR RAYMARINE A75 WiFi - Navigate Menu Options; Navigation

14.6 Navigate menu options
The chart application provides features to help
navigate to a chosen location.
The navigation options are found in the Navigate
menu: Menu > Navigate
• Pilot Controls — Accesses the Pilot Control
Dialog, when Autopilot Control is enabled.
• Goto Cursor — Will set the cursor position as the
active destination.
• Goto Waypoint — Provides options to navigate to
a waypoint stored on the system
• Stop Goto — Stops the Goto Cursor or Goto
Waypoint.
• Stop Follow — Stops following the current route.
• Restart XTE — Restarts the Cross Track Error.
• Advance Waypoint — When following a route,
skips to the next waypoint in the route.
• Follow Route — Provides options to navigate to a
route stored on the system
• Start Track / Stop Track — Will initiate a track on
screen to plot your course as you progress or stop
a track that is currently being created.
• Build Route — Provides options to build a route.
• Race Startline — Provides options to create a
virtual startline.
• Race Timer — Provides a count down timer /
stopwatch.
Refer to
Chapter 13 Waypoints, Routes and Tracks
for details on creating waypoints, routes and tracks.
Navigation
Navigating to a waypoint
With Pilot Control enabled on your MFD, you can
automatically navigate your vessel to a waypoint by
following the steps below.
From the Chart or Radar application:
1. For Wheel and Tiller drive systems follow the
instructions below to engage the mechanical
drive.
• Wheel Pilot: Engage the wheel drive clutch by
rotating the clutch lever clockwise (so the lever
fully engages onto the locating pip).
• Tiller Pilot: Place the pushrod end over the
tiller pin. If necessary, extend or retract the
pushrod by selecting Auto from the Pilot
Control Dialog and using the Left Arrow and
Right Arrow to adjust the rod’s position.
Attention Always reach around (not through) the
wheel to operate the clutch lever.
2. Select the waypoint.
The waypoint context menu is displayed.
3. Select the Goto Waypoint.
The Pilot Control Dialog is displayed.
4. Select Yes (Track).
Note:
• In Track mode you can select Stop Goto option
from the waypoint context menu at any time to
return to Auto (locked heading) or
• you can select Standby to return to manual
vessel control.
Navigating to a waypoint using the waypoints list
From the Chart application:
1. Select WPT.
The waypoint menu is displayed.
2. Select Waypoints.
The waypoints group list is displayed.
3. Browse the waypoints list for the relevant
waypoint.
4. Select the waypoint.
The waypoint options dialog is displayed.
5. For Wheel and Tiller drive systems follow the
instructions below to engage the mechanical
drive.
• Wheel Pilot: Engage the wheel drive clutch by
rotating the clutch lever clockwise (so the lever
fully engages onto the locating pip).
• Tiller Pilot: Place the pushrod end over the
tiller pin. If necessary, extend or retract the
pushrod by selecting Auto from the Pilot
Control Dialog and using the Left Arrow and
Right Arrow to adjust the rod’s position.
Attention Always reach around (not through) the
wheel to operate the clutch lever.
170