6. Select the Goto .
The Pilot Control Dialog is displayed.
7. Select Yes (Track).
Navigating to a location on the chart
From the chart application:
1. For Wheel and Tiller drive systems follow the
instructions below to engage the mechanical
drive.
• Wheel Pilot: Engage the wheel drive clutch by
rotating the clutch lever clockwise (so the lever
fully engages onto the locating pip).
• Tiller Pilot: Place the pushrod end over the
tiller pin. If necessary, extend or retract the
pushrod by selecting Auto from the Pilot
Control Dialog and using the Left Arrow and
Right Arrow to adjust the rod’s position.
Attention Always reach around (not through) the
wheel to operate the clutch lever.
2. Select the required location onscreen.
The chart context menu is displayed.
3. Select Goto Cursor.
The Pilot Control Dialog is displayed.
4. Select Yes (Track).
Note:
• In Track mode you can select Stop Goto option
from the waypoint context menu at any time to
return to Auto (locked heading) or
• you can select Standby to return to manual
vessel control.
Cancelling navigation to a waypoint
Active navigation can be cancelled by following the
steps below.
With Pilot Control enabled on your MFD:
1. Select Standby.
2. For Wheel and Tiller drive systems see below
instructions for disengaging the mechanical drive
to return to manual steering
• Wheel Pilot: Disengage the wheel drive clutch
by rotating the clutch lever anti-clockwise (so
the lever disengages fully from the locating
pip.Attention Always reach around (not
through) the wheel to operate the clutch lever.
• Tiller Pilot: Remove the drive unit from the
tiller pin. If necessary, extend or retract the
pushrod by selecting Auto from the Pilot
Control Dialog and using the Left Arrow and
Right Arrow to adjust the rod’s position.
3. Select any position anywhere on-screen.
The waypoint context menu is displayed.
4. Select Stop Goto.
5. Alternatively, in the chart application, go to: Menu
> Navigate > Stop Goto.
Note: Once navigation is no longer active, the
waypoint symbol returns to its normal state, and
the dashed line between your vessel and the
waypoint is removed.
Chart application
171
To Next Page
Loading...