FLIR RAYMARINE A75 WiFi - Ground Trip Resets Menu; System Settings Menu; Multiple Data Sources (MDS)

Ground trip resets menu
This menu enables you to resets the chosen ground trip distance counter to zero.
Menu item Description
Ground Trip 1 Reset
Resets the ground trip 1 distance counter to zero.
Ground Trip 2 Reset
Resets the ground trip 2 distance counter to zero.
Ground Trip 3 Reset
Resets the ground trip 3 distance counter to zero.
Ground Trip 4 Reset
Resets the ground trip 4 distance counter to zero.
System settings menu
Menu item Description Options
Autopilot
Control
Enables and
disables autopilot
controls from
your multifunction
display.
• On
• Off
DSC Alerts
Enables and
disables DSC
radio alerts on
your multifunction
display.
• On
• Off
GPS Set-up Provides GPS
setting options.
• View Satellite
Status
• Differential GPS
• COG/SOG Filter
• Restart GPS
Internal GPS Switches the
multifunction
displays internal
GPS On or Off.
Note: Not
applicable to
MFDs that do
not include
an internal
GPS/GNSS
Receiver.
• On
• Off
Data Sources Enables selection of
preferred sources of
data for connected
equipment.
Note: The Data
Sources menu is
only available on
displays set as
Data Master.
• GPS
• GPS Datum
• Time and Date
• Heading
• Depth
• Speed
• Wind
External
Devices
Enables set-up
of compatible
externally
connected devices.
Refer to the
External devices
menu section of the
manual.
NMEA Set-up
Enables you to
congure settings
for NMEA devices.
Refer to the NMEA
set-up menu section
of the manual.
Menu item Description Options
System
Preferences
Enables you to
congure system
settings
Refer to the System
preferences menu
section of the
manual.
Simulator Switches simulator
mode On or Off.
• Off
• On
• On (Demo
movie)
Multiple data sources (MDS)
For MDS to be available all products in the system
that use the data sources, must be MDS-compliant.
The system will report any products that are NOT
MDS-compliant. It may be possible to upgrade the
software for these products, to make them compliant.
Visit the Raymarine website (
www.raymarine.com)
to obtain the latest software for your products.
If MDS-compliant software is not available for the
product and you do NOT want to use the systems
preferred data source, you must remove any
non-compliant products from the system. You should
then be able to select your preferred data source.
Note: Once you have completed setting up your
preferred data sources, you may be able to add
non-compliant products back into the system.
Customizing your display
77