FLIR RAYMARINE A75 WiFi - Onscreen Range Controls; Shared Brightness; Setting up Shared Brightness

Onscreen range controls
You can enable and disable onscreen range controls
on HybridTouch displays by following the steps
below.
From the Homescreen:
1. Select Customize.
2. Select Display Preferences.
3. Select Range Controls.
Selecting Range Controls will switch between
showing and hiding the onscreen range controls.
Shared Brightness
You can set up Shared Brightness groups which
enables simultaneous brightness adjustment the all
units that are part of the same group.
The following products are compatible with Shared
Brightness:
• LightHouse
TM
powered MFDs
• SeaTalk
ng®
Instrument displays and Pilot
controllers
• Ray50 / Ray52 / Ray60 / Ray70 VHF DSC Radios
Any adjustments to the Shared Brightness level will
be reected on all units assigned to the same group.
LightHouse
TM
MFD
Instrument display / Pilot
Controller
Ray50 / Ray52 / Ray60 /
Ray70 VHF DSC Radio
Multiple brightness groups can be congured. These
groups could be used to reect the physical location
of units on your vessel. For example, the units at
your helm can be set to one group, and the units on
the ybridge can be set to a different group.
Shared Brightness requires:
• all units to be compatible with the Shared
Brightness function (see list of compatible units
above).
• the Share brightness setting set to On for all units
in the brightness group.
• units to be assigned to Network Groups.
• all the displays in that group to be synchronized.
Setting up shared brightness
With the homescreen displayed:
1. Select Customize.
2. Select Display Preferences.
3. Select Shared Brightness.
4. Select the On option for the Shared brightness
menu item.
5. Select Brightness Group.
6. Select an appropriate brightness group.
7. Repeat the process for the other displays you
want in the brightness group. If the display is not
a multifunction display, refer to the documentation
that accompanies the unit for instructions on
setting-up shared brightness.
8. Once all required displays have been added
to the same brightness group, select Sync
Brightness on the multifunction display.
A shared brightness message is displayed.
9. Ensure all displays in the brightness group are
powered on.
10.Select Sync.
When completed a message is displayed
conrming that shared brightness has been
congured.
Once shared brightness has been successfully
congured, changing the brightness of any display in
that brightness group will automatically change the
brightness of all displays in that group.
Customizing your display
73