FLIR RAYMARINE A75 WiFi - Page 110

Menu item Description Options
Dangerous AIS
targets
AIS target alarms can be enabled and disabled. With
the AIS target alarm disabled AIS targets will not trigger
an alarm when they become dangerous.
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Anchor alarm (drift) When enabled, the Anchor Drift alarm is triggered when
your vessel drifts from your anchor position by more
than the distance specied in the Drift range setting.
Enable:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Drift range
Default values:
• 185 m / 608 ft
Distance range:
• 19 to 3,047 m
• 61 to 9,999 ft
• 0.01 to 1.646 nm
• 0.012 to 1.894 sm
• 0.019 to 3.048 km
Low fuel remaining If the Fuel Manager is not currently enabled then
selecting the Low fuel remaining (LFR) alarm will result
in a message being displayed asking if you want to
enable the Fuel Manager.
The LFR alarm can be enabled and the threshold
can be set without the Fuel Manager being enabled,
however the alarm will not be triggered until the Fuel
Manager is enabled.
Note: You cannot set LFR to be more than the
current TFC value.
Enable:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Fuel level
Default value:
• If Total Fuel Capacity (TFC) has been set in
the Fuel Manager then the default shall be
20% of the TFC value.
Volume range:
• 0 to 99,999 ltr / 0 to TFC
• 0 to 99,999 Gal / 0 to TFC
DSC With the DSC alarm enabled, DSC distress calls will be
displayed on the screen of all networked MFDs.
DSC Alerts:
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
AIS With the AIS alarm enabled, AIS safety messages will
be displayed on the screen of all networked MFDs.
AIS safety messages:
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
MOB Determines whether Position or Dead Reckoning (DR)
data is displayed. Assuming that your vessel and the
MOB are subject to the same tide and wind effects,
the Dead Reckoning setting normally gives a more
accurate course.
MOB data type
• Dead Reckoning
• Position (default)
General Alarms
Menu item Description Options
Alarm Clock
When enabled, an alarm is triggered at the time you
specify in the Alarm Clock Time setting.
Enable:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Alarm Clock Time
110