Ball Down Mode This options should be enables when the
camera is mounted upside down in the
‘ball down’ conguration.
• On
• Off (default)
High Power Standby This option controls the amount of power
used to hold the camera in position while
it is in standby mode. With the setting
enabled the camera will consume more
power, but will help ensure that the
camera is held in place in rough seas.
• On (default)
• Off
JCU Icon Shows or hides the on-screen JCU
connected icon.
• On (default)
• Off
PC Icon Shows or hides the on-screen PC
connected icon.
• On (default)
• Off
Restore Factory Defaults
Enables you to restore the camera’s
settings to factory default values.
Note: The thermal camera menu options available are dependant on the software version of your
multifunction display and thermal camera. If options are different than listed above please refer to the
manual that accompanied your thermal camera and / or the installation and operations handbook which
accompanied your multifunction display.
Thermal camera application — xed mount cameras
325
To Next Page
Loading...