Page 28 Copyright FlyThisSim LLC 2013
Airplane Start-Up Procedures: Before you begin
Note: Use the following procedure only if you are unfamiliar with the TouchTrainer®. This is not the standard startup
checklist one would use for the actual aircraft. After you become familiar with the operation of the TouchTrainer®, use
the aircraft approved Pilot’s Operating Handbook checklists.
Before following this procedure, you must check that you have properly assembled the TouchTrainer® hardware, and that
you have passed the systems’ start-up checks. These checks include network, yoke, rudder, throttle, and X-Plane
connectivity. Follow the procedure corresponding to the aircraft you have loaded:
Cirrus Aircraft:
o Cirrus Avidyne (includes analog aircraft) [Page 29]
o Cirrus Perspective [Page 31]
Cessna Aircraft:
o Steam Gauge (Analog) [Page 33]
o Garmin G1000 [Page 35]
Diamond Aircraft:
o Diamond Analog [Page 37]
o Diamond G1000[Page 39]
Beech Aircraft:
o Beech Analog [Page 41]
o Garmin G1000 [Page 41]
Piper Aircraft:
o Piper Analog [Page 42]
o Piper Avidyne [Page 43]
The shutdown procedure is common to all aircraft, and is located on Page 44.
To Next Page
Loading...