FlyThisSim TouchTrainer - Cirrus Avidyne and Analog Start-Up Procedure; Figure 39: Cirrus Avidyne Panel with no Power; Figure 40: Cirrus Avidyne Panel after Engine Start

To Next Page

To Previous Page

FlyThisSim TouchTrainer® Set-up Guide

Cirrus Avidyne and Analog Start-Up Procedure

Note: The procedure for the Avidyne and analog are similar, and do not require separate start-up guides. Use this guide to

start the Analog aircraft as well as the Avidyne aircraft.

Follow the guide step-by-step, pressing the button that matches the corresponding step in the procedure (i.e. press the

button labeled “1” in the picture below when working on step 1).

Note: Because the button layouts are not exactly the same across all systems, the following pictures may not match your

layout. The correct buttons will still be available, just not necessarily as shown in the pictures.

Figure 39: Cirrus Avidyne Panel with no power

1) Tap BAT1 switch to power up the essential bus.

2) Tap FUEL PRIME once (do not press and hold). After some time, tap FUEL BOOST.

3) Using the hardware controls, adjust mixture to FULL RICH (all the way to the top), and THROTTLE (1/8

from

the bottom). Verify the correct position on the auxiliary monitor.

4) To start the engine, Tap the START once (do not press and hold). The starter will disengage and switch to

BOTH magnetos after a few seconds. If engine does not start, check your throttle/mixture settings and tap the

START touch area again.

Figure 40: Cirrus Avidyne Panel after engine start

5) Turn on BAT2, ALT1, ALT2 and Avionics switches.

6) Turn on NAV and STROBE switches.