FlyThisSim TouchTrainer® Set-up Guide
Copyright FlyThisSim LLC 2013 Page 41
Beech Analog Startup Procedure
Follow the guide step-by-step, pressing the button that matches the corresponding step in the procedure (i.e. press the
button labeled “1” in the picture below when working on step 1).
Note: Because the button layouts are not exactly the same across all systems, the following pictures may not match your
layout. The correct buttons will still be available, just not necessarily as shown in the pictures.
1) Turn on the master and alternator switches by touching the upper half of each switch.
2) Turn on the avionics bus by touching the upper half of the avionics master switch.
Figure 60: Bonanza Analog after Engine Start
3) Complete the GNS-430 startup by pressing the ENT key once for both, verifying the CDI indications, then
pressing the ENT key once more for both.
4) Bring the mixture to full rich and open the throttle slightly on the throttle quadrant.
5) Turn the magneto key to the start position. Note: After the engine starts, the magneto key will snap to the
“BOTH” setting automatically.
6) Use the hat switch on the yoke to move the trim to the takeoff position.
7) Release the parking brake and apply full throttle.
Beech G1000 Startup Procedure
Follow the guide step-by-step, pressing the button that matches the corresponding step in the procedure (i.e. press the
button labeled “1” in the picture below when working on step 1).
Note: Because the button layouts are not exactly the same across all systems, the following pictures may not match your
layout. The correct buttons will still be available, just not necessarily as shown in the pictures.
To Next Page
Loading...