Page 36 Copyright FlyThisSim LLC 2013
6) Turn on ALT MASTER switch.
7) Turn on Avionics 1 and Avionics 2.
8) Turn on lights as necessary.
9) Confirm splash screen on the MFD by pressing the lower right soft-key. Set flaps to 10 degrees. (You can use the
touchscreen or the yoke (right side switch))
Figure 51: Cessna Garmin G1000 after avionics bus powered on
10) Set the elevator trim to the Take Off position.
11) Enter a flight plan if needed (see the Garmin 1000 manual for further information).
12) Release the parking brake. Open throttle to full forward and rotate at the speed indicated on the PFD speed tape.
Figure 52: Cessna Garmin G1000 ready for take-off
To Next Page
Loading...