FlyThisSim TouchTrainer® Set-up Guide
Copyright FlyThisSim LLC 2013 Page 33
Steam Gauge (Analog) Start-Up Procedure
Follow the guide step-by-step, pressing the button that matches the corresponding step in the procedure (i.e. press the
button labeled “1” in the picture below when working on step 1).
Note: Because the button layouts are not exactly the same across all systems, the following pictures may not match your
layout. The correct buttons will still be available, just not necessarily as shown in the pictures.
1) Tap BAT MASTER switch.
2) Tap FUEL PUMP.
3) Tap the parking brake switch to confirm it is engaged (vertical position)
4) Using the hardware controls, adjust mixture to FULL RICH (all the way IN), and THROTTLE (1/8
th
IN). Verify
the correct position on the auxiliary monitor.
5) To start the engine, Tap the START once (do not press and hold). The starter will disengage and switch to BOTH
magnetos after a few seconds. If engine does not start, check your throttle/mixture settings and tap the START
touch area again.
Figure 47: Cessna Analog with no power
To Next Page
Loading...