FlyThisSim TouchTrainer - Chapter 3: Standard Operating Procedures; Control Layout; Figure 63: Yoke Controls; Figure 64: Joystick Controls

FlyThisSim TouchTrainer® Set-up Guide
Copyright FlyThisSim LLC 2013 Page 45
Chapter 3: Standard Operating Procedures
The following chapter provides an overview of normal simulator operations and instructions on how to accomplish
normal simulator tasks. The instructions presented here pertain to the simulation software (X-Plane), and do not
encompass the aircraft panels or systems (provided by SimAVIO). For information regarding SimAVIO operation, please
refer to the SimAVIO Manual, located on your TouchTrainer®’s desktop.
Control Layout
Below is the default layout of the controls as set at the factory.
Figure 63: Yoke Controls
Figure 64: Joystick Controls
Aileron Trim
Roll
May be removed