Maintenance and care
141
Increased moistening
• Position the spacer ring so that the teeth
are facing up and the lug on the tray is
placed between the guides.
• Insert the sealant tray into the housing until
it clicks into place (see page 143).
• Insert sealant tank into the housing with the
cover downward. Close the flap. (See
page 139.)
16.9.3 Cleaning / changing the moistening sponge
The sponge for moistening the envelope flaps should be cleaned regularly (e.g.
always after a weekend). Check the condition of the sponge and replace it if
exhausted. We recommend always keeping a new sponge in reserve.
Warning! Electrical hazards due to short circuits.
Be extremely careful when handling the sealant tank and tray to prevent spilling
any liquids. Make sure not to wetten any parts connected to the mains. If this
should happen, immediately pull the power plugs. Have the PostBase Vision
mailing system checked by the Customer Support before using it again.
• Switch the mailing system off.
To Next Page
Loading...
