Installation and commissioning
31
Step 7: Installing the PostBase Vision Feeder (optional)
Caution! Only connect the Feeder once the
PostBase Vision postage meter is fully
installed. Otherwise the PostBase Vision will
not recognize the feeder. The mailing system
will not work.
Turning off the postage meter
• Press the ON/OFF button for three
seconds.
The PostBase Vision will complete any cur-
rent actions, return the display to its home
position, and then turn itself off.
Setting up the feeder
• Place the ramp, feeder and postage meter
as shown in the illustration above.
• When assembling, ideally proceed from
left to right (starting at the ramp).
Ramp
Feeder
PostBase Vision
postage meter
To Next Page
Loading...
