Maintenance and care
151
Installing the rocker with moistening felt
The rocker features two clips that engage on
the two bolts at the sealer.
• Fit the new rocker such that one leg of the
leg spring is located in the rocker groove
and the other leg in the sealer slot.
• Hold sealer in place, and exerting moder-
ate pressure, push the rocker onto the
sealer such that the two clips engage on
the bolts.
Check
• Check the correct seat:
– The absorption felt must be perpendicu-
larly suspended in the liquid reservoir. Its
lower edge should roughly reach the bot-
tom.
– The gap between rocker and sealer
housing must be uniform. (The rocker
must neither jut out nor touch the hous-
ing.)
• Fill with SEALIT sealing liquid (see
page 148).
• Connect the sealer to the postage meter
(see page 22).
Absorption felt
Rocker
Uniform gap
To Next Page
Loading...
