Rev 4/2018
111
Symptom Problem Solution
Warning lights do not operate
Continued...
Faulty light switch Replace switch.
Poor ground Check ground cable under cab, and
between engine and main frame,
for loose connection or corrosion.
No current to cab
Solenoid stuck or defective Replace solenoid.
Wiring or circuit breaker open Check wiring for a broken or
shorted wire.
Poor ground Check ground cable under cab, and
between engine and main frame,
for loose connection or corrosion.
Steering and ground speed
controls
Machine will not steer straight,
tends to wander when steering
is held still
Centering spring incorrectly
adjusted
Readjust centering spring.
Centering cable broken Replace.
Centering cable caught on
something
Inspect cable for catching.
Centering spring broken Replace.
Binding linkage(s) Check linkage(s) for interference or
bent parts.
Steering binding in steering
column when tilted
Contact your Freeman dealer.
Baler moves on flat ground
with ground speed lever in
neutral and steering wheel
centered
Ground Drive Controls out of
adjustment
Contact your Freeman dealer.
Ground speed surges while
steering
Loose or worn hydro cable Tighten cable joints or replace
cable.
Ground speed handle hard
to move and/or baler pulls
randomly to both sides
Hydro pump jackshaft control
levers not pivoting freely on
jackshaft
Clean shaft and pivots. Grease
jackshaft control lever pivots.
Ground speed control lever
hard to move
Control cable worn Replace.
Damaged dampener Replace.
ELECTRICAL
To Next Page
Loading...