90
Rev 4/2018
Fuel, Coolant And Lubrication
Filling Fuel Tank
CAUTION
Handle fuel with care: It is highly flammable.
Do not refuel the machine while smoking or
when near open flame or sparks.
Always stop engine before refueling
machine. Fill fuel tank outdoors.
Prevent fires by keeping machine clean
of accumulated trash, grease, and debris.
Always clean up spilled fuel.
Do not overfill fuel tank. Fuel level should
not be closer than 25 mm (1 in.) to the top of
the fuel tank. Bodily injury can result from
fuel splash back. Leakage can result from
expansion of fuel. If the tank is filled too full,
then left in direct sunlight or if temperature
gets too hot, the tank will overflow.
The fuel tank is vented at the cap. Fill fuel tank at
the end of each day. This prevents condensation
in the tank as moist air cools.
Hydraulic Pump Drive Gear Case,
Hydrostatic Drive and Main Hydraulic
Systems Oil
IMPORTANT! Do not mix hydraulic oils.
Using only specified oil is recommended.
DO NOT use low viscosity oil.
The baler comes from the factory with Allied
Systems Premium Tractor Hydraulic Fluid, P/N
907895.
Bullgear Grease (if applicable)
Use only Freeman Bullgear Grease F000007626
for lubricating the bullgears.
Wheel Drive Oil
SAE 85W/140 API-GL5 Gear Lubricant is recom-
mended. If other oils are used, they must meet
requirements of:
• API Service Classification GL-5
• Military specification MIL-L-2105B
• Military specification MIL-L-2105C
Depending on the expected prevailing temperature
for the fill period, use oil of viscosity as shown in
the chart.
Product Number Description
244281 85W/140 GL5 Gear Lube
To Next Page
Loading...