Freeman 280 - General Grease (Not for Use on Bullgears)

Rev 4/2018
91
-40ºF
-22ºF
-4ºF
14ºF
32ºF
50ºF
68ºF
86ºF
104ºF
122ºF
-40ºC
-30ºC
-20ºC
-10ºC
0ºC
10ºC
20ºC
30ºC
40ºC
50ºC
SAE 85W-140
SAE 80W-140
SAE 80W-90
SAE 75W-90
SAE 75W
SAE 90
SAE 140
Figure 140. Gear Lubricant
General Grease (not for use on bullgears)
Use grease based on NLGI consistency numbers
and the expected air temperature range during the
service interval.
The following grease is preferred:
• Multi-purpose lithium base #2, EP grease.
Allied part number: LBR0000099
Other greases may be used if they meet the
following:
• NLGI Performance Classification GC-LB
IMPORTANT! Some types of grease are not
compatible with others. Consult your grease
supplier before mixing different types of
grease.
-40ºF
-22ºF
-4ºF
14ºF
32ºF
50ºF
68ºF
86ºF
104ºF
122ºF
-40ºC
-30ºC
-20ºC
-10ºC
0ºC
10ºC
20ºC
30ºC
40ºC
50ºC
Polyurea
HD Moly
Lithium Complex
NLGI # 0
NLGI #1
NLGI # 2
Figure 141. Grease
CAUTION
To prevent injury, never lubricate or service
baler or engine while it is running. Engine
must be off and key removed.
IMPORTANT! The service times are for
average conditions. Service more often if
baler is used in extreme conditions.
Perform each lubrication and service illustrated in
this section both at the beginning of the season,
and at the end of the season.
Clean grease fittings before using grease gun.
Replace any lost or broken fittings immediately. If
a new fitting fails to take grease, remove and check
for failure of adjoining parts.
LUBRICATION AND MAINTENANCE