Freeman 280 - Checking Warning Lights; Check Warning Lights

50
Rev 4/2018
Checking Warning Lights
(See Figure 66)
A
B
Figure 65. Hydrostatic Control Lever in "PARK"
position
A. Hydrostatic drive control lever
B. Neutral start switch
C. Engine air filter
D. Hydrostatic charge
E. Hydrostatic oil filter
F. Operator presence
G. Low fuel
H. Engine oil pressure
I. Engine coolant temperature
J. Hydrostatic oil temperature
K. Alternator
L. Tension pressure low
M. Park brake applied
N. Road shift engaged
H
I
J
K
L
M
N
G
F
E
D
C
Figure 66. Warning Display Panel
NOTICE
Failure to replace a failed light bulb could lead
to serious machine failure. Replace any failed
light bulbs before starting the engine.
NOTE: The warning light check is only
checking the operation of the light bulbs in
the warning display panel.
• Road Shift Engaged (N) will only light if the Field/
Road switch is in the ROAD position.
• Park Brake Applied (M) will only light when the
control lever is fully to the left activating the
neutral start switch (B).
• The Road Shift Engaged and Park Brake Applied
lights (blue) are informational only, not indicating
a hazard when on.
Check Warning Lights:
With hydrostatic drive control lever (A) in neutral
park position (see Figure 65), move lever to the
right to release neutral start switch (B).
PRE STARTING CHECKS