26
Rev 4/2018
INSTRUMENTS AND CONTROLS
Start Switch
See "Operating Engine" on page 51 before
starting the engine.
CAUTION
Sound horn before starting engine to clear
people away from the baler.
Start switch (E) is located on right side of steering
column (see Figure 22).
NOTE: To perform a bulb check, see
CHECKING WARNING LIGHTS in the Oper-
ating Engine section.
NOTE: When starting the machine, if the key
is held in the "ON" position for more than 1 to
2 seconds before advancing to the "START"
position, the ICM (In Cab Monitor) may have
time to completely boot up. If this happens,
then when the key is held in the "START"
position, the ICM may measure voltage below
9 volts resulting in an informational message
that must be cleared before further operating
the baler.
This message is considered normal when it
appears immediately at start up. However, if
this message appears after the machine has
been started, with the engine running or while
baling, it might indicate a possible problem
with the battery or charging system. It is
suggested that these systems be inspected
for proper function.
Turn key (F) from off position (A) to position (D)
to start.
When released, it will return to run position (C).
If engine will not crank, check for:
• Hydrostatic lever in neutral park
• Steering wheel centered and locked
If accessories are to be operated, turn key to
accessories position (B).
A. Off
B. Accessories
C. Accessories and run
D. Start
E. Switch
F. Key
Figure 22. Key Switch
Horn
Press button (A) to sound horn (see Figure 23).
A
Figure 23. Horn
To Next Page
Loading...