Rev 4/2018
7
General Information
The purpose of this manual is to assist the operator in maintaining and operating a Freeman SP Baler.
Please read it carefully, as it provides important information and instructions that will help you achieve
years of dependable equipment performance.
NOTE: Reference to left-hand and right-hand usage throughout this manual refers to the position
when seated in the operator’s seat, facing forward.
Replacement Parts: Only genuine Freeman replacement parts should be used to service the SP Baler.
These parts are available from your authorized Freeman dealer. To ensure prompt and efficient service
when ordering parts or requesting service repairs, remember to provide the dealer with the following
information:
1. The correct part description or part number.
2. The model number of the baler.
3. The serial number of the baler.
Use the Freeman parts books you received with your SP Baler for ordering parts.
The serial number is very important in effectively transacting a parts order or service repair with the
dealer. Use the serial number in all correspondence to ensure proper identification of your Freeman
SP Baler. The serial number is located on the baling chamber as shown.
Figure 1. Baler Serial Number Location
Side Feed Baler Serial Number Format
385E16-123
Drive Type
E - Engine
H - Hydro
D - Driveline
S - Self Propelled
M - Modules
Plunger Size
14", 15", 16", 21"
Sequential
Number
Twines/Bale
2 - 2-Tie
3 - 3-Tie
Knotter
0 - Conventional
5 - Tailless
Model
7 - Base
8 - Premium
Dash - No Option
G - Gearbox
To Next Page
Loading...