12
Rev 4/2018
Fire Safety
WARNING
Diesel fuel and hydraulic oil are flam-
mable. Never smoke while handling fuel or
working on the fuel system. The fumes in an
empty fuel container are explosive. Never
cut or weld on or near fuel lines, tanks, or
containers. Keep open flames and sparks
away from the machine.
Reduce the Risk of Fire
• Keep the baler free of oil,
grease, hay, and trash accu-
mulations. Regular cleaning
is recommended for
fire prevention and
general safety. Use an
approved solvent to
clean machine parts.
Never use gasoline or diesel fuel.
• Shut off the engine and electrical equipment
while filling the fuel tank. Use extra caution
when fueling a hot engine. Always ground
the fuel nozzle against the filler neck to avoid
sparks.
• Never overfill the fuel or hydraulic tanks. Any
overflow could cause a fire. Immediately repair
any hydraulic or fuel leaks and clean up any
spills.
• Handle all solvents and dry chemicals
according to procedures identified on manu-
facturer’s containers. Work in a well-ventilated
area. Make sure you know where fire extin-
guishers are kept and how to use them.
• Avoid spilling fuel or other hazardous liquids. If
a spill occurs, follow local or state regulations
for clean-up. Contact your state’s OSHA office
for details.
• Always ensure that excess grease and oil
accumulation, including spillage, is cleaned
up immediately.
• Inspect the baler daily for potential fire hazards
and make any necessary repairs immediately.
• Check all the electrical wiring and connections
for defects, and repair or replace as necessary.
Keep battery terminals clean and tight.
• Never perform welding operations until the
entire machine has undergone a thorough
cleaning. In addition, cover rubber hoses,
disconnect the battery, ECM (Electrinic Control
Module) located on engine, XA2 module located
on the chassis frame near the engine and ICM
(In Cab Monitor). The ICM is located in the
overhead console inside the cab but can be
disconnected at bulkhead labeled X911 behind
cab. Failure to disconnect these items could
result in permanent damage. Have at least a
fire extinguisher at hand. Contact your dealer
with any questions.
• Hydraulic fluid is flammable. Do not weld on or
near pipes, tubes, or hoses that are filled with
fluid. Do not smoke when checking or filling
the tank. Keep open flames and sparks away
from the baler.
• Hay dust is combustible. Do not have an open
flame or weld in dusty environments.
• Maintain the engine cooling system to avoid
overheating.
• Remember, there is always a risk of fire.
Fire Fighting Equipment
• It is recommended to carry an “ABC” fire extin-
guisher on the baler at all times. Install it within
easy reach of the operator in a position that
protects it from damage. Use only a “quick
release” type of mount. It is also recommended
to carry a four gallon water container with a
pump, or as required by local and state law.
• Keep your fire extinguisher(s) fully charged and
in good working order. Know how to use them.
To Next Page
Loading...