Rev 4/2018
27
INSTRUMENTS AND CONTROLS
Bullgear Luber Button (not available on
Gearbox Balers)
Press button (A) to distribute grease on bullgears
(see "Bullgear Luber (if applicable)" on page 82
for more information). This button is not available
on gearbox bailers.
A
Figure 24. Bullgear Luber Button
Turn Signals
NOTE: The turn signals are not self cancel-
ling. Right and left turn indicator lights (A)
glow steadily in direction of indicated turn.
Turn signals (see Figure 25) are operable whenever
ignition key is in ACCESSORIES or ACCESSO-
RIES AND RUN position.
When operating the baler on the road or highway,
use the turn signals when turning the baler.
Amber lights in front, and amber and red lights at
rear of machine, will flash at 90 flashes a minute
in direction of indicated turn.
Corresponding lights on the opposite side of the
machine will burn steady.
A. Turn Indicator Lights
Figure 25. Turn Signals
Steering Wheel Height Adjust
CAUTION
To prevent loss of control, adjust steering
wheel only when baler is stopped.
NOTE: Only a slight tightening of the hub (A)
is needed to hold steering wheel in position.
Loosen hub (A). Push or pull wheel to desired posi-
tion. Tighten hub to lock (see Figure 26).
A. Hub
Figure 26. Steering Wheel
To Next Page
Loading...