Freeman 280 - Page 94

94
Rev 4/2018
ITEM
ITEM
DESCRIPTION
POINTS DESCRIPTION
APPROVED
MATERIAL
Break-in
*Engine, see engine manufacturer's operator's manual
3 Wheel drive 2 Replace oil (only after first 50 hours)
SAE 85W/140
API-GL5
3
Wheel drive cover cap
screws
24 Tightento75n•m(55lb-ft)(onlyafterrst50hours)
3 Front wheel nuts 24
Tighten after first hour and then every 4 hours until
tight
8 Rear wheel cap screws 12
Tighten after first hour and then every 4 hours until
tight
14 Engine* oil and filters 2 Replace oil and filter (only after first 100 hours)
40 Bullgears (if applicable) 2 See bullgear luber in settings and adjustments
Freeman bullgear
grease, F000007626
only.
As required
*Engine, see engine manufacturer's operator's manual
1 Fuel tank 1 Drain water and sediment
Engine* fuel system Bleed fuel system
9
Oil cooler—a/c
condenser
1 Clean debris from fins
11 Radiator 1 Add coolant/clean debris from fins
16, 17
Engine* air screen or
primary air filter
2
Clean screen or primary filter when warning light
comes on
17 Engine* air filters 2 Replace
Engine* fuses 2 Check
20 Cab fresh air filter 1 Replace
20 Cab pre-cleaner 1 Replace
23 Cab recirculating filter 1 Replace
Every 3 to 4 hours
2 Pickup clutch 1 Grease / 1 pump Multi-purpose grease
5
Needle yoke drive rod
ends
4 Grease
6 Plunger rollers 4 Grease
10 Plunger stop dog 1
Grease / make sure stop dog moves freely when
greasing.
13 Con rod / plunger side 1 Grease
22 Hay saver wheel 1 Grease
25
Torque shaft bearing
housing
1 Grease
40 Bullgears (if applicable) 2 See bullgear luber in settings and adjustments
Freeman bullgear
grease, F000007626
only.
LUBRICATION AND MAINTENANCE