Chapter 3
OPERATION USING THE KEYPAD
This chapter describes inverter keypad operation.
Contents
3.1 Name and Function of Each Keypad Part ···································································· 3-1
3.2 Overview of Operation Modes ·················································································· 3-3
3.3 Running Mode ······································································································ 3-5
3.3.1 Operating state monitor ··················································································· 3-5
3.3.2 Status display ································································································ 3-7
3.3.3 Monitoring warnings ························································································ 3-8
3.3.4 Running or stopping the motor with the keypad ····················································· 3-9
3.3.5 Setting the reference frequency with the keypad ··················································· 3-9
3.3.6 Setting PID commands with the keypad ····························································· 3-10
[ 1 ] Settings under PID process control ··································································· 3-10
[ 2 ] Settings under PID dancer control ····································································· 3-12
3.3.7 Jogging operation ·························································································· 3-14
3.3.8 Switching between local and remote modes ························································ 3-15
3.3.9 Changing the M/Shift key function ····································································· 3-16
3.3.10 Display when keypad operation disabled (command source display) ························ 3-16
3.4 Programming Mode ······························································································· 3-17
3.4.1 Setting function codes “Data Setting: 1.f__ to 1.k__” ········································ 3-18
3.4.2 Checking changed function codes “Data Checking: 2.rep” ··································· 3-20
3.4.3 Monitoring the running status “Drive Monitoring: 3.ope” ······································· 3-21
3.4.4 Checking I/O signal status “I/O Checking: 4.i_o” ················································ 3-25
3.4.5 Reading maintenance information “Maintenance Information: 5.CHE” ······················ 3-31
3.4.6 Reading alarm information “Alarm Information: 6.al” ··········································· 3-37
3.4.7 Copying data “Data Copying: 7.Cpy” ································································ 3-41
3.4.8 Setting “Favorites” function code data “Favorites: 0.fnC” ······································ 3-45
3.5 Alarm Mode ········································································································· 3-46
3.5.1 Releasing the alarm and switching to running mode ·············································· 3-46
3.5.2 Displaying the alarm history ············································································· 3-46
3.5.3 Displaying the status of inverter at the time of alarm ············································· 3-46
3.5.4 Switching to programming mode ······································································· 3-46
3.6 USB Port ············································································································ 3-47
To Next Page
Loading...
