EasyManuals Logo
Home>Fuji Xerox>All in One Printer>DocuCentre S2110

Fuji Xerox DocuCentre S2110 User Manual

Fuji Xerox DocuCentre S2110
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #193 background imageLoading...
Page #193 background image
Error Code
193
Problem Solving
11
The drum cartridge needs to
be replaced.
Turn the power off, wait for 10 seconds after
the display is turned off, and then turn the
power on again.
If the display cannot be turned off, replace
the drum cartridge.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
The machine cannot detect
the drum cartridge.
Remove the seal on the drum cartridge.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
The drum cartridge is
defective.
Replace the drum cartridge.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
The warranty period of the
image quality on the drum
cartridge is expired.
It may affect the image quality. Replacing
the drum cartridge is recommended.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
The warranty period of
performance on the drum
cartridge is expired.
It may damage the machine. Replace the
drum cartridge.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
The drum cartridge is
defective.
Replace the drum cartridge immediately.
Otherwise, the machine will be damaged.
Reference
z
Refer to "Replacing the Drum Cartridge" (P.153).
Reached the maximum copy
limit while the limit is set.
Also, the user who reached
the copy job limit has logged
in.
Press the <Stop> button, and contact your
system administrator.
A job is canceled due to out of
memory in reading.
Change the setting, and then try again.
A job is canceled. Change the setting, and then try again.
Error Code Cause and Remedy
003-500 [Cause]
When using the Pages per Side function, the printout doesn't fit in
the paper with the specified reduction/enlargement factor.
[Remedy]
Press the control panel's <Stop> button, and change the setting.
003-754 [Cause]
An IPS error occurred.
[Remedy]
Press the control panel's <Stop> button, and cancel the job.
003-795 [Cause]
When enlarging/reducing a scanned document to the paper size
specified, the reduction/enlargement ratio exceeds the allowed
range.
[Remedy]
Press the control panel's <Stop> button, and change the setting.
Error Code Cause Remedy

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre S2110 and is the answer not in the manual?

Fuji Xerox DocuCentre S2110 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre S2110
CategoryAll in One Printer
LanguageEnglish

Related product manuals