Using CentreWare Internet Services
33
Environment Settings
2
z
IP Address:
You can enter the IP address for entry.
z
UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
z
SNMP Version:
You can specify the SNMP version for entry as [v1] or [v2c]. (Default: v1)
z
Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code
characters). (Default: SNMP_trap)
z
Trap to be Received:
You can set whether to send notification of [Print], [Cold Start], and [Authentication
Failure] events.
[Add UDP IPv6 Address] button
You can add a recipient address for UDP IPv6 trap notification by pressing this button.
z
IP Address:
You can enter the IP address for entry.
z
UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
z
SNMP Version:
You can specify the SNMP version for entry as [v1] or [v2c]. (Default: v1)
z
Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code
characters). (Default: SNMP_trap)
z
Trap to be Received:
You can set whether to send notification of [Print], [Cold Start] and [Authentication
Failure] events.
[Delete] button
You can delete the traps specified for the trap notification recipient IP address by pressing
this button.
[Edit] button
You can display notification information of the trap you are using. You can specify the
events for which to send notification.
[Apply] button
You can apply changes by pressing this button.
z
Reboot the machine to enable new settings.
LPD (Connectivity > Protocols)
You can set the LPD port.
General
LPD Port Status
You can check [Enabled] to use LPD. (Default: On)
Physical Connection
[Ethernet] is displayed.
To Next Page
Loading...
Need help?
General
