Environment Settings
34
Environment Settings
2
Port Number
You can set the LPD port No. (a value between 1 and 65535). You must set a unique
number for each port. (Default: 515)
Connection Time-Out
You can set the timeout period that the machine waits before terminating the connection
when incoming data stops (between 2 and 3600 seconds). (Default: 60)
Maximum Connections per Port
The maximum number of connections is displayed.
[Apply] button
You can apply changes by pressing this button.
z
Reboot the machine to enable new settings.
Port9100 (Connectivity > Protocols)
You can set Port9100.
General
Port9100 Port Status
You can check [Enabled] to use Port9100. (Default: On)
Physical Connection
[Ethernet] is displayed.
Port Information
TCP Port Number
You can set the Port9100 port No. (a value between 1 and 65535).
You must set a unique number for each port. (Default: 9100)
Maximum Connections per Port
The maximum number of connections is displayed.
End of Job Timeout
You can set the amount of time the machine waits before terminating the connection
when incoming data stops (between 2 and 3600 seconds). (Default: 60)
PDL Switching
[Enabled] is displayed.
[Apply] button
You can apply changes by pressing this button.
z
Reboot the machine to enable new settings.
HTTP (Connectivity > Protocols)
You can set the HTTP protocol.
To Next Page
Loading...
Need help?
General
