22 1 Basic Operation
1.4 Setting/Exiting the Power Saver Mode
The scanner has the Power Saver feature which reduces the power consumption during the
periods of inactivity.
As delivered, the scanner automatically switches to the Power Saver mode 10 minutes after
the last operation.
During the Power Saver mode, all indicator lamps on the control panel except for the
<Power Saver> button go out. The touch panel also goes blank and displays nothing.
The factory default setting of 10 minutes is changeable within the range of 1 to 60 minutes.
The scanner consumes less than 9 W during the Power Saver mode, and returns to the
ready-to-scan state in about 12 seconds when re-activated.
Note
• The Power Saver mode can be disabled.
Refer to
• For more information about the Power Saver mode, refer to "Auto Power Saver (P. 137)".
Exiting the Power Saver Mode
To ex
it the Powe
r Sa
ver mode
, press
the <P
ower Sav
er> bu
tton on t
he contr
ol pane
l.
To Next Page
Loading...