Input signal type
The input signal type can be selected by using Central remote controller interface.
To select the input signal type, do as follows:
1. Tap Menu button.
2. Tap “Installer Setting”.
3. Tap “External Input Setting”.
4. Tap “Operation” and select following operation for external input.
• Emergency Stop: Enables Emergency stop by external input
• All On/Off: Enables batch operation on or off by external input
• Not Used: Does not receive external input signals
5. Tap “Input method” and select following input method.
• Edge button: Detects the signal rise and fall
• Pulse button: Detects the signal level
Pulse
Edge
The width of pulse must be
longer than 300 msec.
6. When “OK” button is tapped, setting is complete.
4-2. Central remote controller (UTY-DCG
Z)
- (08-34) - 4. Controller
EXTERNAL INPUT
AND OUTPUT
EXTERNAL INPUT
AND OUTPUT
To Next Page
Loading...
