Indoor unit address setting
1. In the initial display of setting mode, by pressing the SET BACK button, select a remote con-
troller address. (Select the indoor unit you want to operate.)
Example: When remote controller address “01” is selected
Remote controller address
2. Display the function number “01” by pressing the SET TIME “<” button or SET TIME “>” button.
3. Set up the indoor unit address by pressing the SET TEMP. “ ” or the SET TEMP. “ ” button.
(The setting range is from “00” to “63”.)
Example: When indoor unit address data “12” is set up
Indoor unit address data
4. Confirm the selected indoor unit address data by pressing the TIMER SET button. The data will
be transferred to the indoor unit.
• When the address data is properly set up on the indoor unit, the flashing of the number stops
and the set number will be displayed. (GOOD)
• When the address data is not set up correctly, “- -” is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
1-4. Address setting by remote controller
- (07-29) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
