Fujitsu AJ 126LELDH Series - Page 829

 Entering setting mode
1. While displaying Monitor Mode screen, press and hold the TEMP. “ ” button and FAN “ ”
button at the same time for 2 seconds or longer. Menu 1 screen will be displayed.
Monitor Mode screen Menu 1 screen
2. While displaying the Menu 1 screen, press and hold the FAN “ ” button for 2 seconds or
longer. Setting mode selection screen will be displayed.
Menu 1 screen Setting mode selection screen
3. Press the TEMP. “ ” or TEMP. “ ” button to select “F1” (Menu 2-F1) settings mode or F2
(Menu 2-F2) settings mode.
• F1: Initial settings mode
• F2: Maintenance settings mode
4. While displaying the settings mode selection screen, press START/STOP
/
button. Setting
item selection screen with item number will be displayed.
Item number
Setting mode selection screen Setting item selection screen
5.
While displaying the setting item selection screen with item number, press the TEMP. “ ” or
TEMP. “
” button to select the item number “13”.
Item number
Setting item selection screen
1-4. Address setting by remote controller
- (07-33) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS