6. After adjusting the item number to “13” in Menu 2-F1 settings, press the START/STOP
but-
ton to switch to the function setting screen.
Setting item selection screen Function setting screen
Item number
RELATED LINKS
"Indoor unit address setting" on page 07-34
"Refrigerant circuit address setting" on page 07-36
"Indoor unit function setting" on page 07-97
Indoor unit address setting
NOTE: Perform this setting on the master remote controller.
1. While displaying the function setting screen, press the TEMP. “
” or TEMP. “ ” button to se-
lect the 2-wire remote controller address.
Function setting screen
Example: Selecting the 2-wire remote
controller address (002-01)
2. Press the START/STOP
button to switch to the function number setting.
Example: Selecting the 2-wire remote
controller address
Function number
3.
Press the TEMP. “
” or TEMP. “ ” button to adjust the function number.
Function number Function number
1-4. Address setting by remote controller
- (07-34) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
